Jawbone pairing manual

Once you see this, you can proceed to step 3. Option 2: Start with headset off slide the power switch to OFF, the position where you cannot see the blue indicator.

Press and hold the button on the back of the headset and slide the power switch to ON. Continue to hold down the button until you see the LED light flash red and white the LED surrounds the little rubber piece that rests against your cheek, then release the talk button. The headset is now in pairing mode and you can continue to step 3. If you wear the Jawbone, you can test the connection by placing a call from your iPhone. Start the Jawbone Bluetooth headset off and put it into pairing mode if you need to manually turn it on.

The NoiseAssasin button needs to be held down and turned on. Hold down the button for 2 seconds to continue. When the headset is in paring mode, it will flash red and white. It is most likely that you will need to perform a Bluetooth Reset or a Software Update to resolve this issue. Hold down the NoiseAssasin button and power on. Continue to hold down button for 2 seconds. Headset will flash red and white when it is in paring mode. If you are having trouble with this step, try pushing in the NoiseAssassin button just a half a second before you push in the talk button.

There are Bluetooth devices near you that you can discover. Table of contents 1. If your Jambox is off like in the picture above , turn it off.

Your Jambox needs to be unplugged before use. The light should be on immediately. The earbuds should be removed from the charging case. The power button needs to be held down. The charging case should now be open.